Various Parts And Its Function In Internal Combustion Engine.

Internal combustion engines are made from various parts.Each part has its own location and function for proper working of engine.Some important parts
and its function is as described below.

01) Cylinder Block:-
Function- In the bore of cylinder the fresh charge of air-fuel mixture is ignited,compressed by piston and expanded to give power to piston.

02) Cylinder Head:-
Function-It carries inlet and exhaust valve.Fresh charge is admitted through inlet valve and burnt gases are exhausted from exhaust valve.In case of petrol
engine,a spark plug and in case of diesel engine,a injector is also mounted on cylinder head.

03) Piston:-
Function-During suction stroke,it sucks the fresh charge of air-fuel mixture through inlet valve and compresses during the compression stroke inside the
cylinder.This way piston receives power from the expanding gases after ignition in cylinder.Also forces the burnt exhaust gases out of the cylinder through
exhaust valve.

04) Piston Rings:-
Function-It prevents the compressed charge of fuel-air mixture from leaking to the other side of the piston.Oil rings,is used for removing lubricating oil from the cylinder after lubrication.This ring prevents the excess oil to mix with charge.

05) Connecting Rod:-
Function-It changes the reciprocating motion of piston into rotary motion at crankshaft.This way connecting rod transmits the power produced at piston to

06) Gudgeon Pin:-
Function-Connects the piston with small end of connecting rod.

07) Crank Pin:-
Function-hand over the power and motion to the crank shaft which come from piston through connecting rod.

08) Crank Shaft:-
Function-Receives oscillating motion from connecting rod and gives a rotary motion to the main shaft.It also drives the camshaft which actuate the valves of the engine.

09) Cam Shaft:-
Function-It takes driving force from crankshaft through gear train or chain and operates the inlet valve as well as exhaust valve with the help of cam
followers,push rod and rocker arms.

10) Inlet Valve & Exhaust Valve:-
Function-Inlet valve allow the fresh charge of air-fuel mixture to enter the cylinder bore.Exhaust valve permits the burnt gases to escape from the cylinder
bore at proper timing.

11) Governor:-
Function-It controls the speed of engine at a different load by regulating fuel supply in diesel engine.In petrol engine,supplying the mixture of air-petrol and controlling the speed at various load condition.

12) Carburettor:-
Function-It converts petrol in fine spray and mixes with air in proper ratio as per requirement of the engine.

13) Fuel Pump:-
Function-This device supply the petrol to the carburettor sucking from the fuel tank.

14) Spark Plug:-
Function-This device is used in petrol engine only and ignite the charge of fuel for combustion.

15) Fuel Injector:-
Function-This device is used in diesel engine only and delivers fuel in fine spray under pressure.

I hope,above information will help you something about your vehicle's engine.



No responses found. Be the first to comment...

  • Do not include your name, "with regards" etc in the comment. Write detailed comment, relevant to the topic.
  • No HTML formatting and links to other web sites are allowed.
  • This is a strictly moderated site. Absolutely no spam allowed.
  • Name: